When it comes to gas water heaters there are three usual problems that are normally seen. The first one is that the water heater does not heat water at all.  The second is it heats it up but it does not do so in the desired amount and lastly the pilot light does not stay lit. Here are some recommendations from your friendly Minneapolis plumber water heater experts.

No Heat

The first thing that you need to check is to ensure that the gas to the water heater is turned on. To do so, you need to put into PILOT the gas control knob so as to prevent the burner from igniting when you are peering inside. Carefully remove the metal cover located at the bottom and check to see if the burner as well as the pilot light, which is the small flame, located at the end of the pilot gas tube is also lit up.

No Pilot Light

Refer to the instructions on the tank on how to relight it. Check also the gas inlet valve to determine if it has been closed fully or just partially. If it is, just turn the handle parallel to the line and then relight the pilot. If it still does not light up, it is possible that the thermocouple could be at fault. If you live in Minneapolis there are water heater repair experts you can call to repair the problem right away.

Burner not on

To correct the problem, replace the cover and ensure that the thermostat is set to at least 120 degrees Fahrenheit.  If done, turn the hot water faucet on and wait for a few minutes to determine if the water heater burner begins to ignite. If it does not, just leave it running and attempt to lower and raise the temperature setting until it does.

When Burner Ignites

Put the cover back and then turn the thermostat to its correct level. At this point if the burner does not ignite, have it checked by a certified technician.

Check for Gas

If you notice a garlic-like scent, please turn the gas valve control to OFF and then wait until such time that the smell has disappeared prior to relighting the pilot light. If the smell is too strong and does not go away, turn the gas control valve off immediately, open the windows to ventilate and call the utility company.

When it comes to gas water heaters there are three usual problems that are normally seen. The first one is that the water heater does not heat water at all.  The second is it heats it up but it does not do so in the desired amount and lastly the pilot light does not stay lit. Here are some recommendations from your friendly Minneapolis plumber water heater experts.

No Heat

The first thing that you need to check is to ensure that the gas to the water heater is turned on. To do so, you need to put into PILOT the gas control knob so as to prevent the burner from igniting when you are peering inside. Carefully remove the metal cover located at the bottom and check to see if the burner as well as the pilot light, which is the small flame, located at the end of the pilot gas tube is also lit up.

No Pilot Light

Refer to the instructions on the tank on how to relight it. Check also the gas inlet valve to determine if it has been closed fully or just partially. If it is, just turn the handle parallel to the line and then relight the pilot. If it still does not light up, it is possible that the thermocouple could be at fault. If you live in Minneapolis there are water heater repair experts you can call to repair the problem right away.

Burner not on

To correct the problem, replace the cover and ensure that the thermostat is set to at least 120 degrees Fahrenheit.  If done, turn the hot water faucet on and wait for a few minutes to determine if the water heater burner begins to ignite. If it does not, just leave it running and attempt to lower and raise the temperature setting until it does.

When Burner Ignites

Put the cover back and then turn the thermostat to its correct level. At this point if the burner does not ignite, have it checked by a certified technician.

Check for Gas

If you notice a garlic-like scent, please turn the gas valve control to OFF and then wait until such time that the smell has disappeared prior to relighting the pilot light. If the smell is too strong and does not go away, turn the gas control valve off immediately, open the windows to ventilate and call the utility company.